VEGA VEGAMET 514V - Manual (Page 51)

VEGAMET 514V 51
E031 Same DISBUS address. At least one other instrument with the same DISBUS
address is connected to the DISBUS. Please check the DISBUS address.
E032 Instrument address 0. Instrument address 0 is adjusted on VEGAMET. With
this address VEGAMET does not participate in the DISBUS communication,
even if the DISBUS is wired. If necessary, modify the instrument address.
E034 Instrument error. A considerable error was detected on the instrument (possi-
bly defective EEPROM). Disconnect voltage and then connect again (cold
start). If the error is not eliminated, please contact your VEGA agency.
E035 Instrument error. A considerable error was detected on the instrument (check
sum error in EPROM). Disconnect voltage and then connect again (cold start).
If the error is not eliminated, please contact your VEGA agency.
E050 Remote VEGAMET not found. The VEGAMET from which a measured value is
expected cannot be found.
Reasons:
- the remote VEGAMET is not connected
- no VEGAMET with this instrument address connected
- line break (DISBUS)
- shortcircuit (DISBUS)
- the remote VEGAMET is defective
- interfered communication (DISBUS)
Probably
- failure on the DISBUS transmitter/receiver part of VEGAMET
Please check the instrument address on both VEGAMET, the connection cable,
the remote VEGAMET and, if necessary, this VEGAMET.
E051 Failure during transmission of measured values via DISBUS. It is not possible
to receive a valid measured value via DISBUS from the remote VEGAMET; the
communication with the remote VEGAMET, however, is okay.
Reason:
- failure on remote VEGAMET
- the input on the remote VEGAMET which should be transmitted is not yet
configured
Please check the remote VEGAMET and, if necessary, its input configuration.
E052 The input number of the VEGAMET from which a measured value is expected
has not yet been assigned.
E060 Span of the current output values too small. The values for the current output
are too close togehter or are identical. Please check the adjustment of the
current output.
Error code Meaning
Diagnosis