M-AUDIO Pro Tools Recording Studio - Manual (Page 95)

Chapter 6: I/O Setup 77
To set which output path is muted when tracks are
soloed in AFL or PFL Solo mode:
1 Choose Setup > I/O.
2 Click the Output tab to display the Output
page.
3 Select a path from the AFL/PFL Mutes (Output
Path) pop-up menu.
4 Click OK to save your changes to the I/O Setup
and close the I/O Setup dialog.
Default Path Order
(Pro Tools HD and Pro Tools LE with Complete
Production Toolkit Only)
The Default Path Order pop-up menu lets you se-
lect the default track layout you want Pro Tools
to follow when creating and mapping 5.1-for-
mat main or sub-paths in the I/O Setup dialog.
This selector is only available in the Output page
of I/O Setup dialog.
This setting does not affect existing path defini-
tions or metering—it only specifies channel
mapping in new 5.1-format paths.
To choose a Default Path Order:
„ Select the channel mapping from the Default
Path Order pop-up menu.
Mic Preamps
(Digidesign PRE with Pro Tools HD Only)
On the Mic Preamps page of the I/O Setup dia-
log, signal paths for one or more Digidesign PRE
multi-purpose microphone preamplifiers can be
mapped to Pro Tools HD audio interfaces. For
more information, see the PRE Guide.
H/W Insert Delay
Compensation
(Pro Tools HD Only)
To compensate for the delay (latency) of any ex-
ternal hardware devices (such as an effects unit)
used in your session, you can set the amount of
Delay Compensation (in milliseconds) for each
external device. These times will be used by the
Delay Compensation Engine to time-align input
paths when the hardware insert is in use and De-
lay Compensation is enabled.
Default Path Order selector
For more information about multichannel
mixing, see Chapter 44, “Pro Tools Setup
for Surround.”
Insert offset delay field
Insert offset delay field