9035 rear i/o modules -5, Installation and setup, Installing a rear i/o module – Cobalt Digital COMPASS 9035 Analog and SDI Input to SDI Output Converter User Manual

Page 37: 9035 rear i/o modules

Advertising
background image

9035-OM (V4.4)

9035 PRODUCT MANUAL

2-5

Installation and Setup

Installing a Rear I/O Module

Figure 2-2 Rear I/O Module Installation

9035 Rear I/O Modules

Table 2-1 shows and describes the full assortment of Rear I/O Modules
specifically for use with the 9035.

Note:

Rear I/O Modules equipped with 3-wire Phoenix connectors are supplied with
removable screw terminal block adapters. For clarity, the adapters are omit-
ted in the drawings below.

DSCN3483A.JPG

Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.

Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.

DSCN3487A.JPG

Note: Rear I/O Modules RM20-9035-C, -D, -E, and -F occupy two

rear module slot mounting locations and use two captive
screws.
Rear I/O Module RM20-9035-G occupies three rear module
slot mounting locations and uses three captive screws.

1

2

Advertising