Cobalt Digital COMPASS 9035 Analog and SDI Input to SDI Output Converter - Manual (Page 45)

9035-OM (V4.4) 9035 PRODUCT MANUAL 3-1
Chapter 3
Chapter 3
Operating Instructions
Overview
This chapter contains the following information:
• Control and Display Descriptions (p. 3-1)
• Accessing the 9035 Card via Remote Control (p. 3-5)
• Checking 9035 Card Information (p. 3-7)
• Ancillary Data Line Number Locations and Ranges (p. 3-8)
• 9035 Function Submenu List and Descriptions (p. 3-9)
• Troubleshooting (p. 3-52)
Control and Display Descriptions
This section describes the user interface controls, indicators, and displays for
using the 9035 card. The 9035 functions can be accessed and controlled using
any of the user interfaces described here.
The format in which the 9035 functional controls, indicators, and displays
appear and are used varies depending on the user interface being used.
Regardless of the user interface being used, access to the 9035 functions (and
the controls, indicators, and displays related to a particular function) follows a
general arrangement of Function Submenus under which related controls can
be accessed (as described in Function Submenu/Parameter Submenu
Overview below).
Note: DashBoard™ and the Remote Control Panel provide greatly simplified user
interfaces as compared to using the card edge controls. For this reason, it is
strongly recommended that DashBoard™ or a Remote Control Panel be
used for all card applications other than the most basic cases. Card edge
control codes are not included in this manual. If card-edge control is to be
used, obtain a copy of “Manual Supplement – Card-Edge Control Reference
Master List and Instructions for Using Compass
®
Card-edge (Local) Control
Codes” (989CEC-MS.pdf) at
www.cobaltdigital.com>Support>Documents>Reference Guides.
If you are already familiar
with using DashBoard or a
Cobalt Remote Control
Panel to control Cobalt
cards, please skip to 9035
Function Submenu List and
Descriptions (p. 3-9).