Operating instructions, 9035 function submenu list and descriptions – Cobalt Digital COMPASS 9035 Analog and SDI Input to SDI Output Converter User Manual

Page 77

Advertising
background image

9035-OM (V4.4)

9035 PRODUCT MANUAL

3-33

Operating Instructions

9035 Function Submenu List and Descriptions

(continued)

• Metadata Embedding

Metadata Embedding (On/Off) controls SMPTE 2020-1 metadata
embedding in the SDI video output.

• When set to On, metadata from selected source is embedded in the

output SDI video.

• When set to Off, metadata is not embedded in the output SDI video.

Note: Metadata Embedding should only be set to “On” if new metadata is
to be embedded. Existing metadata on the SDI input is passed through
the card unaffected, requiring no operator intervention.

• Metadata Embedder Source

When metadata embedding is enabled, selects the metadata source to be
embedded.

Dolby Decoder: Selects 9035-DEC Dolby

®

decoder metadata as

the metadata source. (For example, when adding or replacing old
metadata with new metadata generated by the decoder.)

Input Video: This setting is currently not needed for normal use of

the 9035-DEC.

Note: Typically, Metadata Embedder Source should be set to “Dolby

Decoder”, since this is the new metadata produced by the
9035-DEC decoder and should also be made available in the SDI
stream. If embedding new metadata, make certain to set its line
number such that such that any old metadata for the same purpose
is overwritten (i.e., new metadata set to the same line number as the
old metadata to be replaced).

• Metadata Serial Out Source

Selects the metadata source to be sent to the 9035-DEC DOLBY META
RS-485 port.

Dolby Decoder: Selects 9035-DEC Dolby

®

decoder metadata as

the metadata source. (For example, when decoder metadata is
desired for other local systems.)

Input Video: Selects SMPTE 2020-1 metadata from the input SDI

video as the metadata source. (This can be used to extract existing
SDI metadata and make it available on the 9035-DEC RS-485
output.)

Note: Typically, Metadata Serial Out Source should be set to “Dolby

Decoder”, since this is the new metadata produced by the
9035-DEC decoder.

Table 3-2

9035 Function Submenu List — continued

Advertising