Cobalt Digital COMPASS 9035 Analog and SDI Input to SDI Output Converter - Manual (Page 51)

9035-OM (V4.4) 9035 PRODUCT MANUAL 3-7
Operating Instructions
Checking 9035 Card Information
Checking 9035 Card Information
The operating status and software version the 9035 card can be checked using
DashBoard™ or the card edge control user interface. Figure 3-4 shows and
describes the 9035 card information screen using DashBoard™ and accessing
card information using the card edge control user interface.
Note: Proper operating status in DashBoard™ is denoted by green icons for the sta-
tus indicators shown in Figure 3-4. Yellow or red icons respectively indicate
an alert or failure condition. Refer to Troubleshooting (p. 3-52) for corrective
action.
Figure 3-4 9035 Card Info Utility
The Tree View shows the cards seen by
DashBoard™. In this example, Network Controller
Card MFC-8320-N (serial number ...8055) is
hosting a 9035 card in slot 10.
Software Release Number and
Software Build Number
Refer to these numbers to check that documentation (such as
this manual) matches the card’s Software Release Number
and Software Build Number. Use these numbers also when
communicating to Cobalt
® regarding this card.
Power Consumption Display
This display shows the power consumed by the 9035 for both
the +12V and -7.5V rails.
Status Displays
These displays show the status the signal being received by the
9035. Green Settings icon shows that any changes made on
DashBoard™ are sucessfully saved on the card’s memory.
9035_CARD_INFO.PNG