Embedded audio group 1/2, Embedded audio group 1/2 -21, Operating instructions – Cobalt Digital COMPASS 9035 Analog and SDI Input to SDI Output Converter User Manual
Page 65: 9035 function submenu list and descriptions
9035-OM (V4.4)
9035 PRODUCT MANUAL
3-21
Operating Instructions
9035 Function Submenu List and Descriptions
Embedded Audio Group 1/2
This function selects the audio source for each embedded
audio channel 1 thru 8 (Embedded Audio Groups 1 and 2). It
also provides Gain and Phase Invert controls for each
channel.
Table 3-2
9035 Function Submenu List — continued
The example above shows
various Source selections and
individual audio control settings
for various audio sources fed to
the Destination channels
Embedded Ch 1 thru
Embedded Ch 8 in Embedded
Audio Groups 1 and 2, with the
resulting setup (right).
The source-to-destination
correlation shown here is only
an example; any of the sources
on the left can connect to any of
the destinations on the right, or
to Embedded Audio Groups 3
and 4 (not shown here).
Additional sources not shown
here are also available. These
are described on the following
pages.
The controls shown here are
described in detail on the
following pages. Refer to Audio
Routing Example Using
DashBoard™ (p. 3-47) for more
examples of using these
controls.
Embed Ch 12
Embedded
Audio Group 1
AES I/O (1-4)
AES IN (5-8)
AN-AUD
IN (1-8)
0 dB
0 dB
0 dB
0 dB
20 dB
20 dB
15 dB
TG1
+
+
+
+
+
+
–
-10 dB
Embedded SDI
Channels 1 – 16
Embed Ch 14
AES Ch 1
AES Ch 3
AES Ch 5
AES Ch 8
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
Embedded
Audio Group 2
Analog Ch 3