SENA ProBee-ZS10 - Manual (Page 43)

43 ProBee-ZS10 User Guide Rev.1.5
5.2.4 ATE
Description Echo(1) or No Echo(0).
Execute ATE<number><CR>
Response OK<CR>
5.2.5 ATM
Description
Enter the multicast mode. If there’s no argument after the command, it will connect to
the preconfigured destination group ID(AT+DESTGROUPID). Every data is packetized
at intervals of inter character timeout(S12).
Execute ATM<CR> ATM<groupID><CR>
Response OK<CR>
5.2.6 ATO
Description Return to data mode.
Execute ATO<CR>
Response
5.2.7 ATR
Description Response(1) or No Response(0).
Execute ATR<number><CR>
Response OK<CR>
5.2.8 ATS
Description Get/Set the S-registers.
Execute ATS<CR> ATS<number>?<CR> ATS<number>=<value><CR>
Response
List of the S-register and
description <value><CR>
OK<CR>
OK<CR> or ERROR<CR>
5.2.9 ATZ
Description Reset the node.
Execute ATZ<CR>
Response OK<CR>
5.2.10 AT&F
Description Factory reset.
Execute AT&F<CR>
Response OK<CR>