6 at+stack or at+zs, 7 at+nodename or at+nn, 5 network formation and join – SENA ProBee-ZS10 User Manual
Page 47: 1 at+ascan or at+as, 2 at+escan or at+es, At+stack or at+zs, At+nodename or at+nn, Network formation and join, At+ascan or at+as, At+escan or at+es
47
ProBee-ZS10 User Guide Rev.1.5
5.4.6 AT+STACK
or
AT+ZS
Description
Get/Set the ZigBee stack profile value. This value must be set the same on all devices
that should join the same network. (0: Network specific, 1: ZigBee, 2: ZigBee Pro)
Execute AT+STACK?<CR>
AT+STACK=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 0
Range
0 - 2
5.4.7 AT+NODENAME
or
AT+NN
Description
Get/Set the node name. It can be used to make a clear distinction role or functionality
of local node from others.
Execute AT+NODENAME?<CR>
AT+NODENAME=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default ProBee-ZS
Range
Up to 16 characters
5.5
Network Formation and Join
5.5.1 AT+ASCAN
or
AT+AS
Description
Perform a scanning for existing network. It can take up to 5 seconds.
(CAUTION: It is possible to cause a link error if a node is a parent of an end-device.)
Execute AT+ASCAN<CR>
AT+ASCAN=<channel mask><CR>
Response
<channel>|<PAN ID>|<EPID>|<joinable>|<stack profile>
List of the existing networks
…
OK<CR>
5.5.2 AT+ESCAN
or
AT+ES
Description
Perform a scanning for energy level of all channels. It can be used to avoid
interference. It can take up to 5 seconds. The RSSI energy level ranges from
approximately -100 to +127 in dBm at PTv1.4 or later. It is the real RSSI value plus an
offset of +154 at PTv1.3 or earlier. (CAUTION: It is possible to cause a link error if a
node is a parent of an end-device.
)
Execute AT+ESCAN<CR>
AT+ESCAN=<channel mask><CR>
Response
<channel>|<RSSI >
List of the RSSI for each channel
…
OK<CR>