SENA ProBee-ZS10 - Manual (Page 61)

61 ProBee-ZS10 User Guide Rev.1.5
7.1.2 S12
Description Get/Set the command echo mode.
Execute ATS12?<CR> ATS12=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 1
Range
0 – 1
7.1.3 S13
Description Get/Set the command responses mode.
Execute ATS13?<CR> ATS13=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 1
Range
0 - 1
7.1.4 S14
Description
Get/Set the LED mode. It causes the LED operation if the device is ZS10 or ZE10 set
GPIO1, 2 to specific functionality.
0: LEDs are always OFF regardless of configuration or status.
1: LEDs are OFF when the node is under sleep status.
2: LEDs always operate by the case.
Execute ATS14?<CR> ATS14=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 1
Range
0 - 2
7.2 Network Settings
7.2.1 S21
Description
Get/Set the inter character timeout in milliseconds. It determines to send data packet
after this time.
Execute ATS21?<CR> ATS21=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 100
Range
0 - 10000