5 at+oppanid or at+oi, 6 at+opepid or at+oe, 7 at+version or at+vr – SENA ProBee-ZS10 User Manual
Page 45: 8 at+productname or at+pn, 4 network specific parameters, 1 at+chmask or at+cm, At+oppanid or at+oi, At+opepid or at+oe, At+version or at+vr, At+productname or at+pn
45
ProBee-ZS10 User Guide Rev.1.5
5.3.5 AT+OPPANID
or
AT+OI
Description
Get the operating 16-bit PAN ID. If PAN ID is set specific value not 0s, operating PAN
ID will equal designated PAN ID. A value of “FFFF” means the device is not joined a
network.
Execute AT+OPPANID?<CR>
Response
<value><CR>
OK<CR>
5.3.6 AT+OPEPID
or
AT+OE
Description
Get the operating 64-bit extended PAN ID. A value of “FFFFFFFFFFFFFFFF” means
the device is not joined a network.
Execute AT+OPEPID?<CR>
Response
<value><CR>
OK<CR>
5.3.7 AT+VERSION
or
AT+VR
Description
Get firmware version of the module. The firmware version returns a form of “PTvx.x”.
Execute AT+VERSION?<CR>
Response
<value><CR>
OK<CR>
5.3.8 AT+PRODUCTNAME
or
AT+PN
Description
Get the product name. It can be used to distinguish among different hardware
platforms.
Execute AT+PRODUCTNAME?<CR>
Response
<value><CR>
OK<CR>
5.4
Network Specific Parameters
5.4.1 AT+CHMASK
or
AT+CM
Description
Get/Set the channel mask to use. Bits set as 1 indicate that this particular channel can
be used. Bits set as 0 indicate that this particular channel should not be used. For
example, a channel mask value of 0x00000001 indicates that only channel 0 should be
used. Valid channels range from 12 to 25 inclusive. (14 channels are available.) This
translates to a channel mask value of “0x03FFF000”.
Execute AT+CHMASK?<CR>
AT+CHMASK=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 03FFF000