SENA PS210W - Manual (Page 26)

26
Figure 3-3 Operation mode configuration
 Connect to any
The PSx10W attempts to connect to any nearby AP regardless of the List of APs. PSx10W tries to
connect to AP in the order searched.
 Connect in the order of registraion
The PSx10W attempts to connect to AP in the order of the registered APs.
 Connect in the order of signal strength
The PSx10W attempts to connect to AP in the order of signal strength of the registered APs. The list in
the order of signal strength is updated for every 30 seconds.
Note : If you use same SSID for some APs, PSx10W may connect to other APs. It often causes
wireless disconnection and low performance.
3.2.3. List of APs
This menu is enabled when the “Network type” is Infra mode. If the Operation mode is not “Connect
any”, the AP to which the PSx10w connects should be registered. If you use ADD or REMOVE
command, you should use SAVE command. In case, ‘Save & Apply’command, the changed things are
reflected in systems directly.