SENA PS210W - Manual (Page 96)

96
-------------------------------------------------------------------------------
Hardware Test
-------------------------------------------------------------------------------
Select menu
0. Test Mode - One Time
1. Auto test
2. DRAM test
3. FLASH test
4. EEPROM test
5. Ethernet test
6. UART Mode test
<ESC> Back, <ENTER> Refresh
-----> 1
******* Hardware auto-detect and auto-test *******
[DRAM]
DRAM Test ---------------------------------------------[SKIPPED]
[FLASH]
FLASH Test ---------------------------------------------[SKIPPED]
Figure A-10 Skip the specific test using ESC key
A 4.5. Firmware upgrade menu
By using the ‘Firmware upgrade’menu, the user can upgrade the firmware of the unit. Before firmware
upgrade, the user can check the current firmware version by selecting menu item 3 from the Main
menu page . The firmware upgrade menu supports only the TFTP protocol for remote firmware
download. If the user would like to download firmware from TFTP server, he must also set the IP
address for the unit properly. The default IP address for the unit is 192.168.161.5.
For firmware upgrade, a firmware file configured as [Firmware File Name] on the server configured as
[Server’s IP address] must exist.
-----------------------------------------------------------------------------
Firmware upgrade
-----------------------------------------------------------------------------
Select menu
1. Protocol [TFTP]
2. IP address assigned to Ethernet interface [192.168.161.5]
3. Server's IP address [192.168.0.128]
4. Firmware File Name [ps.img]
5. Start firmware upgrade
<ESC> Back, <ENTER> Refresh
----->
Figure A-11 Firmware upgrade menu within Bios Menu Program
If the user selects [Start firmware upgrade], a confirmation message will be displayed on the screen. If
the user enters ‘y’, the firmware upgrade process will start. This process cannot be stopped until it
has finished.