SENA PS210W - Manual (Page 55)

55
is set) response for this case, he can get the required result after setting CONNECT strings as
shown on Figure 4-8.
Respond to AT&Cn, AT&Wn and AT&Zn with
For the following three AT commands,
AT&Cn, AT&Wn, AT&Zn
User can select the response as one of OK or ERROR.
Command echo delay(ms)
AT commands that are entered by user can be echoed with a delay specified in this menu.
This is useful if user uses modem emulation mode in RS485 mode.
Default command echo
User can disable or enable echo of AT command that is entered by user in this menu.
(Same functionality to ATEn command)
Default data mode
User can select the TCP data mode between Raw TCP mode and Telnet binary mode. The Raw
TCP means that there is no application protocol over the TCP protocol. The Telnet binary mode
means that there is Telnet protocol over the TCP protocol. The Telnet binary mode supports the
Telnet COM Port Control Option defined by RFC2217. When selecting this option with a COM
Port Redirector compatible with RFC2217, user is able to control the serial port parameter of the
Pro Series through a serial port application such as Hyperterminal.
Figure 4-8 Host mode configuration (Modem emulation mode)