GE Industrial Solutions Entellisys 4.0 System Administrator Manual - Manual (Page 60)

Preparing and configuring a replacement CPU 60
12
Step 3
• After selecting the option string, the Step 3 – Set Default IP dialog box will display as shown
below. This will change the configured address within the HMI to the default address of a
new CPU in preparation for communicating with it in Step 4.
NOTE: If the IP Address of the CPU has already been set or if the CPU is not functioning, select
Skip This Task and click Next. Otherwise, click Next and the CPU IP address will be changed. The
current IP configuration will be stored before it is changed.
Figure 12-9 Step 3 – Set Default IP dialog box
• A series of messages will display confirming the status of changes as they are being made.
NOTE: After performing this step the CPU may be powered down and physically swapped out.
Please refer to DEH-234 Entellisys Low Voltage Switchgear Device Replacement Guide,
Chapter 1, “Replacing a CPU chassis”, for this procedure prior to proceeding to the next section.