GE Industrial Solutions OKCV3000CN DeviceNet - Manual (Page 48)

GEl-100343
DnetStAuxCode Meaning
0 No additional information
1 All available group 2 message identifiers have been allocated
2 Invalid initial comm characteristic attribute
3 All available group 1 message identifiers have been allocated
4 All available group 3 message identifiers have been allocated
5 Invalid value within the transportClass trigger attribute
6 An Apply request is sent to a Connection instance when it is in the Established or
Timed-out state
7 Illegal to send fragmented explicit Connection message
8 Connection object must be in Established state and must be Messaging type of
Connection_in_order to_send_a_cnxn-based_request
Cannot send cnxn-based request since a request is outstanding
9
10 Invalid instance identifier specified in received explicit message request
11 Explicit message request is directed at non-existent cnxn instance
12 A Create request can only be sent to the class, not a particular instance
13 ConfigCnxnndex already set
14 Unable to create cnxn class
15 Apply attribute cannot be sent to the cnxn class, only a specific instance
16 Invalid service code received in explicit message request
17 Class specified in received Cnxn Based Explicit request message does not exist
18 More than.2 group 2 object have been created
19 Maximum number of allocatable group 3 identifiers already allocated
20 Group specified in open messaging connection is invalid
21 Invalid service code received in received ucmm request message
22 Duplicate MacId check response has been received
23 Duplicate MacId check request has been received
24 Cannot send open cnxn-based request since a request is outstanding
25 A connection within the client is not available
26 Timerld not correct
27 expected packet rate not supported (is greater than maximum allowed)
28 No more Timer available
29 watchdog timeout action not correct
30 Watchdog time-out occured
31 UCMM time-out occured
32 Explicit time-out occured
33 Attempt to deallocate a CAN channel not allocated
34 No more CAN channel available
35 No more CAN channel available for transmission
36 CAN Interrupt register error
37 CAN is still in hardware reset
38 CAN status register error
39 Error on allocation
40 BusOff detected
41 Error on de-allocation
42 Too much data
43 Parameter object data type not correct
44 Connection path not correct
45 I/O length not correct
50 1st step of drive reset failed
51 2nd step of drive reset failed
52 3rd step of drive reset failed
400..499 This is the parameter IPA that caused the error
TNetl2O
APPENDIX B
S