GE Industrial Solutions OKCV3000CN DeviceNet - Manual (Page 57)

10(33) 3
20(66) 3
30 (98) 2.06
40 (131) 1.57
50 (164) 1.26
60 (197) 1.01
70 (230) 0.91
80 (262) 0.80
90 (295) 0.71
100 (328) 0.64
Table D.9.2.
Power configurations
Depending on your power requirement use one of the following configurations
Single-supply. End-connected
For thick cable trunk line, if the accumulated current requirement for your network exceeds the value found in
Table D.9. 1, then this configuration is not appropriate for your network. Similarly, for thin cable trunk line, if the
accumulated current requirement for your network exceeds the value found in Table D.9.2, then this configura-
tion is not appropriate for your network.
Power
Tap
~1~~
Power
Supply
-F--
Ni
EJHFIHEEiE~J
Figure D.2: Single Power Supply, End Connected
Single-supply, end-connected is the simplest configuration but also provides the lowest power capability.
LYlE
APPENDIX D