Extron Electronics TPX 88 A User Guide - Manual (Page 32)

Operation, cont’d
TPX 88 Matrix Switchers • Operation 3-6
I/O grouping
I/O grouping is an RS-232/RS-422 controlled feature that allows you to subdivide
the front panel control of the matrix into up to four smaller functional sub-
switchers. Inputs and outputs can be assigned to one of four groups (figure 3-4) or
not assigned to any group. Once assigned to a group, inputs and outputs can only
be tied within that group from the front panel. For example, a front panel operator
cannot tie an input that is assigned to group 1 to an output that is assigned to group
2. Ungrouped inputs and outputs can be switched to outputs and inputs in any
group.
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
I
N
P
U
T
O
U
T
P
U
T
I
N
P
U
T
O
U
T
P
U
T
3 input, 2 output
MTP composite matrix
Camera #1
Camera #3
Monitor
Projector
USP 405 Computer #1
Computer #2
3 input, 3 output
MTP S-video matrix
VCR
DVD
Monitor
Monitor
Document Camera
Group 1 Group 2
Group 1 Group 2 Group 3
2 input, 3 output
RGBHV matrix
6
7
8
7 8
Input
Output
1 2 3
Input
1
2 Output 3
4
4 5 6
Input
Output
5
Group 3
Monitor
DVS 406
NEXT
MENU PICTURE ADJUSTMENTS
DIGITAL VIDEO SCALER
4 2 1 3 5 6
VIDEO/
S-VIDEO RGB/YUV RGB VIDEO/
S-VIDEO VIDEO/
S-VIDEO SDI TAKE COL/TNT BRT/CONT DETAIL SIZE CENTER DVS 406
ADJUST
USP 405 UNIVERSAL SIGNAL PROCESSOR
ADJUST MENU
NEXT FREEZE 1 2 3 4 5
PICTURE ADJUSTMENTS CENTER SIZE BRT/CONT COL/TNT ZOOM DETAIL INPUTS RGB UNIVERSAL FREEZE COMPOSITE S-VIDEO SDI
USP 405
USP 405 UNIVERSAL SIGNAL PROCESSOR
ADJUST MENU
NEXT FREEZE 1 2 3 4 5
PICTURE ADJUSTMENTS CENTER SIZE BRT/CONT COL/TNT ZOOM DETAIL INPUTS RGB UNIVERSAL FREEZE COMPOSITE S-VIDEO SDI
Figure 3-4 — I/O grouping of compatible twisted pair
transmitter/receiver pairs
The I/O groups can be set up only by using the RS-232/RS-422 port and either the
SIS or the Windows control program (see chapter 4, Programmer’s Guide, and
chapter 5, Matrix Software. Ties between groups (an input in group 1 tied to an
output in group 2) can be created under RS-232/RS-422 control. Presets can also be
created under RS-232/RS-422 control that tie inputs and outputs across group
boundaries. These presets are selectable from the front panel.
Suggested applications for the I/O grouping feature include:
• Segregating specific twisted pair transmitter and receiver formats to prevent
a transmission from one family of twisted pair transmitters from being
inadvertently applied to a twisted pair receiver from an incompatible family.
See the table on page 1-3 and page 1-4 for twisted pair transmitter and
receiver compatibility.
• Segregating specific video formats to prevent an input in one video format
from being inadvertently applied to an output device that supports another
video format.
• Segregating input and output devices that are in separate rooms.
• Isolating video from being displayed on specific output devices for
operational security reasons.