Operation, cont’d – Extron Electronics TPX 88 A User Guide User Manual
Page 46
Operation, cont’d
TPX 88 Matrix Switchers • Operation
3-20
Viewing and adjusting the input audio level (TPX 88 A only)
On the TPX 88 A, the audio level of each input can be displayed and adjusted
through a range of -18 dB to +24 dB to ensure that there is no noticeable volume
difference among sources. The audio level can be adjusted from the front panel or
under RS-232/RS-422 control.
The input level adjustment does not affect the audio portion of the twisted pair
link output on RJ-45 connectors.
The input level adjustment will not work for an input whose tied local output
is muted. If one or more local outputs are muted, press the Mute All button
once or twice as necessary to turn off the Mute All LED.
1
.
Press and hold the I/O button until the Audio LED begins to blink red, then
release the I/O button.
2
.
Press and release an input button to select an input. The output buttons
display audio level and polarity (+ or -) for the selected input. Green output
buttons indicate a gain (+) audio level and red buttons indicate an attenuation
(-) level.
3
.
Rotate the volume knob to increase and decrease the audio level.
4
.
Press and release the I/O button to save the setting and exit the audio display
and adjustment mode. The Audio LED returns to unlit.
•
There is one audio level setting per input. The audio level setting is
shared by the left and right audio inputs.
•
The audio level settings are stored in non-volatile memory. When power
is removed and restored, the audio level settings are retained.
Example 7: Viewing and adjusting an input audio level
The following steps show an example in which an audio level is viewed and
adjusted. Where an explanation is helpful, the steps show the front panel
indications that result from your action.
The input level adjustment will not work for an input whose tied local output
is muted. If one or more local outputs are muted, press the Mute All button
once or twice as necessary to turn off the Mute All LED.
1
.
Press and release the Esc button.
2
.
Press and hold the I/O button for approximately 2 seconds (figure 3-35).
VIDEO
AUDIO
I/O
VIDEO
AUDIO
I/O
Press and hold the button.
2 seconds
= Blinking LED
Figure 3-35 — Select audio view and adjust mode