Extron Electronics TPX 88 A User Guide - Manual (Page 43)

3-17 TPX 88 Matrix Switchers • Operation
5 . Press and release the View button to exit view mode (figure 3-28).
VIEW
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
I
N
P
U
T
O
U
T
P
U
T
I
N
P
U
T
O
U
T
P
U
T
All input and output buttons return to unlit or background illumination.
Press the View button
to exit view mode.
The View LED goes out.
Figure 3-28 — Press the View button to exit view mode
Using presets
The current configuration (configuration 0) can be saved as a preset in any one of
16 preset memory addresses, or, as many presets as the switcher has input and
output buttons.
• Only the audio and video ties are stored and recalled; audio gain settings
are not saved, and they do not change when a preset is recalled.
• Presets cannot be viewed from the front panel unless recalled as the
current configuration. Presets can be viewed using Extron’s Windows-
based control program. See Chapter 5, Matrix Software, for more details.
• The current configuration and all presets are stored in non-volatile
memory. When power is removed and restored, the current configuration
is still active and all presets are retained.
• When a preset is recalled, it replaces the current configuration, which is
lost unless it is also stored as a preset. The recalled preset overwrites all of
the current configuration ties in favor of the preset configuration ties.
Example 5: Saving a preset
The following steps show an example in which the current configuration is saved
as a preset. Where an explanation is helpful, the steps show the front panel
indications that result from your action.
1 . Press and release the Esc button.
2 . Press and hold the Preset button for approximately 2 seconds (figure 3-29).
PRESET PRESET
Press and hold the button.
2 seconds
= Blinking LED
Figure 3-29 — Enter save preset mode