Avision @V2800 - Manual (Page 136)

129
Replacing the ADF Snap-in Pad Module
After scanning approximately 30,000 pages through the ADF, the pad may be worn
out and you may experience problems with document feeding. In this case, it is
highly recommended to replace the pad module with a new one. For ordering the
pad module, please consult your nearest dealer and follow the procedure below to
replace it.
Disassembling Procedure
1. Pull the ADF Release button and open the ADF front cover to the left.
2. Press the top of the ADF snap-in pad as illustrated to raise the holder.
3. Press both sides of the holder inwardly to remove it from the slot.
4. Press both sides of the ADF snap-in pad inwardly with your fingers to pull out
the ADF snap-in pad from the slot.
ADF Snap-in
Pad Holder
ADF Release
Button
The Top of the
ADF Pad Holder
ADF Snap-in
Pad
1 2
3 4
ADF Front
Cover