Moulinex MULTI MOULINETTE AT712G - Manual (Page 25)

• Do not place the appliance, the power cord or the plug in water or any other liquid.
• Your appliance is for domestic use only. In the event of any commercial use,
inappropriate use or failure to comply with the instructions, the manufacturer
accepts no responsibility and the guarantee will not apply.
• For your own safety, only use the Moulinex accessories and spare parts suitable for
your appliance.
• For your safety, this appliance complies with applicable standards and laws:
- Low Voltage Directive
- Electromagnetic Compatibility
- Environment
- Materials in contact with food.
Before using for the first time, wash the accessories (C, D, E, F & G) in soapy water.
Rinse and dry carefully.
Attention: the blades are very sharp, handle cutting accessories (E & F) with caution
when using or cleaning your appliance. Always take the blade accessories by the upper
part taking care not to touch the blades.
Chopping and Blending (blades E & F):
For coarse chopping, the lower blade can be used on its own. For finer chopping,
blending, pureeing, etc. using both the blades gives a superior result.
• Place the blending bowl (G) on a clean dry surface where it will not slip.
• Place the lower blade (F) inside the blending bowl and on the bowl shaft (H) (Fig. 1).
• Fit the upper blade (E) onto the lower blade (F) already in place in the bowl (Fig. 1).
Note: If you are using only the lower blade, ignore this step.
• Add the ingredients (see ingredients table below) without exceeding the maximum
level (Fig. 2):
• Cut larger pieces into cubes around 1-1.5 cm or as needed to fit easily into the
blending bowl.
• Remember that chopping hard foods such as coffee beans, spices, ice cubes or
ice will wear the knife blades faster.
• Now put on the seal lid (C) (Fig. 2).
• Place the motor unit (B) on the top by turning slightly to correctly position it on
the bowl (G) (Fig. 3).
• Plug in the appliance and press the On/Off button (A), while at the same time
holding the appliance by the bowl (G) so that it does not turn. You may select
either a low speed (A1) or a higher speed (A2 Turbo) (Fig. 7).
• At the end of preparation, release the On/Off button (A1 or A2 Turbo), unplug the
appliance and wait until the blades (E and/or F) come to a complete stop.
• Remove the motor unit (B), the seal lid (C) and the blades (E and/or F) to pour
out the preparation.
23
BEFORE USING FOR THE FIRST TIME