ALLIED Vision Technologies Pike F-1600 - Manual (Page 115)

Camera interfaces
PIKE Technical Manual V5.1.2
115
Blink codes are used to signal warnings or error states:
The following sketch illustrates the series of blinks for a Format_7_error_1:
You should wait for at least 2 full cycles because the display of blinking codes
starts asynchronously - e.g. on the second blink from S2.
Class S1
Error code S2
Warning

1 blink
DCAM

2 blinks
MISC

3 blinks
FPGA

4 blinks
Stack

5 blinks
FPGA boot error 1-5 blinks
Stack setup 1 blink
Stack start 2 blinks
No FLASH object 1 blink
No DCAM object 1 blink
Register mapping 3 blinks
VMode_ERROR_STATUS 1 blink
FORMAT_7_ERROR_1 2 blinks
FORMAT_7_ERROR_2 3 blinks
Table 24: Error codes
Figure 60: Warning and error states