Trigger inputs (cc1) – ALLIED Vision Technologies Bonito CL-400 200 fps User Manual
Page 32
Camera Link interface (01-04 or CL1, CL2)
Bonito Technical Manual V2.3.0
32
functions. Both Camera Link serial interfaces (and also the third RS-232 inter-
face at the 15-pin D-sub connector) are virtually equal. They all use one global
baud rate setting. They also share the same receive buffer. Output characters
(including echo) are always sent to all activated serial ports. The ports are not
intended for concurrent activity, although it might be possible under particular
circumstances.
However, the serial ports at O2 and O4 (or at CL1) may be deactivated.
Trigger inputs (CC1)
The two Camera Link connectors O2 and O4 (or connector CL1) each provide a
camera control signal CC1. A rising edge at either input may start an exposure.
It depends on the trigger input selection
T
and the current trigger mode
M
,
which of the two CC1 inputs is enabled and how it controls the exposure time.
Note
The Bonito CL-400B/C 200fps cameras provide only one Cam-
era Link channel. The serial interface via Camera Link is only
available at the CL1 connector.
Note
•
For more information on serial interface configuration:
see chapter
Serial control interface configuration (s)
•
Consult the documentation of the frame grabber for more
information on how to operate its integrated serial
ports.
Note
The Bonito CL-400B/C 200fps cameras provide only one
Camera Link channel. The serial interface via Camera Link is
only available at the CL1 connector.
Note
For more information on the various trigger and exposure
modes: see chapter