eLine Technology EYS-VMS eyStream User Manual Part2 User Manual
Page 7
107
Recording to Archive and Initiation of an Alarm
To configure recording to the archive and the initiation of an alarm when a detection tool is
triggered, you must perform the following steps:
1. Add the Record to archive rule (see
Adding an automatic rule
).
2. In the Alarm list (1), select the mode for initiating a system alarm.
3. In the Camera list (2), select the video camera for which the rule will be performed.
4. In the Record to list (3), select the archive to which you need to record the video image
(and audio signal, if configured accordingly) when the detection tool is triggered.
Attention!
Recording from the detection tool video camera to this archive must be
setup (see the section
Configuring Recording of the Video Stream from
Video Cameras to the Archive
)
5. Click the plus button (4), then add and configure additional rule settings:
a. In the Alarm flag position field (1), enter the number of seconds by which the alarm
eLineTechnology.com
303.938.1133