eLine Technology EYS-VMS eyStream User Manual Part2 - Manual (Page 9)

109
The following procedure is used for displaying video cameras:
1. The system searches for layouts that contain the specified video camera and are accessible
to the user.
2. The system chooses the layout with the minimum number of cells to display the selected
video camera.
3. If the required layout does not yet exist, the system creates a new layout with a single
video camera.
4. The system switches to the selected layout.
5. The video camera becomes active in the selected layout, and the viewing tile is expanded by
one level.
Switching Relays
To configure the switching of a relay when a detection tool is triggered, you must perform the
following steps:
1. Add the Switch relay rule (see Adding an automatic rule ).
2. In the Switching relay list (1), select the Relay object corresponding to the relay which
needs to be switched when the detection tool is triggered. Any enabled relay in the system
can be used, including one tied to another server.
3. In the At field (2), enter the length of time for which the relay should be in switched status.
4. To save changes, click the Apply button.
Configuration of switching a relay when a detection tool is triggered is now complete.
Switching to a PTZ camera preset
To configure switching to a PTZ camera preset, you must perform the following steps:
1. Add the Go to preset rule (see Adding an automatic rule ).
eLineTechnology.com 303.938.1133