Burkert Type 8650 - Manual (Page 109)

109
1.2. Shutdown
1.2.1. Safety Instructions
DANGER!
Risk.of.injury.from.high.pressure.in.the.equipment!
• Before loosening the lines and valves, turn off the pressure and vent the lines.
Risk.of.injury.due.to.electrical.shock!
• Before reaching into the system, switch off the power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
(It is permitted to replace electronic modules and valves even while the power is on.)
WARNING!
Risk.of.injury.from.improper.installation!
• Removal may be carried out by authorized technicians only and with the appropriate tools!
Risk.of.injury.from.unintentional.activation.of.the.equipment.and.an.uncontrolled.restart!
• Secure equipment to prevent unintentional activation.
1.2.2. Shutting down the system
→
Vent the system.
→
Switch off the power supply.
→
Remove the modules. The procedure is described in the chapter “Installation / Removal of Individual
Segments”.
→
Keep the modules in their original packaging or in similar protective packaging.
1.2.3. Restarting the system
→
Unpack and acclimatize the modules before restarting the system.
→
Start-up is described in the chapter “Commissioning / Initialization”.
Type 8650
english
Storage, Packaging,
Transport, Disposal