Burkert Type 8136 - Manual (Page 52)

Code
Text mes-
sage Cause Rectification
S600
Unpermissible
electronics
temperature
l Temperature of the elec-
tronics in the non-specified
section
l Check ambient tempera-
ture
l Isolate electronics
l Use instrument with higher
temperature range
S601
Overfilling
l Danger of vessel overfilling l Make sure that there is no
further filling
l Check level in the vessel
The following table shows the error codes and text messages in the
status message "Maintenance" and provides information on causes as
well as corrective measures.
Code
Text mes-
sage Cause Rectification
M500
Error with the
reset delivery
status
l With the reset to delivery
status, the data could not
be restored
l Repeat reset
l Load XML file with sensor
data into the sensor
M501
Error in the
non-active lin-
earization ta-
ble
l Hardware error EEPROM l Exchange of the elec-
tronics
l Send instrument for repair
M502
Error in the
diagnosis
memory
l Hardware error EEPROM l Exchange of the elec-
tronics
l Send instrument for repair
M503
Reliability too
low
l The echot/noise ratio is the
small for a reliable meas-
urement
l Check installation and
process conditions
l Clean the antenna
l Change polarisation direc-
tion
l Use instrument with higher
sensitivity
M504
Error on an
device inter-
face
l Hardware defect l Check connections
l Exchange of the elec-
tronics
l Send instrument for repair
Maintenance
52 LEVEL TRANSMITTER 8136 • 4 … 20 mA/HART - two-wire
9 Diagnosis, Asset Management and service
41783
-EN
-120316