Clear-Com HX System Frames - Manual (Page 49)

6 Upgrading the Eclipse HX-PiCo
This chapter describes how to upgrade the Eclipse HX-PiCo matrix, including the PROM, FPGA and
application code.
The Eclipse HX-PiCo PROM is different from the PROM used with the CPU cards, which are fitted to
the Eclipse HX-Median, Eclipse HX-Omega and Eclipse HX-Delta matrices. Care should be taken to
ensure that the correct PROM is fitted.
Note:
If you are upgrading your PiCo to an HX-PiCo please contact your Clear-Com representative to
establish if your hardware is HX ready. If your PiCo hardware is not HX ready then this is a factory
only upgrade..
Note:
This guide is laid out in the order in which you must upgrade your Eclipse HX software and hardware
devices. For a quick reference to upgrading your system, see
3 Quick reference: Upgrading to Eclipse HX.
Note:
The HX-PiCo mainboard needs a factory hardware modification.
Eclipse HX devices are powered by mains voltage. Unless specifically
advised to the contrary, disconnect mains supply before carrying out any
maintenance or repair tasks. Observe precautions for handling electrostatic
sensitive devices.
6.1 Changing the Eclipse HX-PiCo PROM
Important note:
When you change the Eclipse HX-PiCo PROM, you must also change the Eclipse HX-PiCo RAM
(from 128Mb RAM to 256Mb RAM). See 6.2 Changing the Eclipse HX-PiCo RAM below.
To upgrade the Eclipse HX-PiCo PROM:
1. Ensure that you have the following equipment:
Required equipment Description / comments
2MBit PROM device (ST
M27W201 or equivalent).
-
PROM Programming Unit You will also require the appropriate programming
software for the unit.
The appropriate S record file for
the Eclipse HX-PiCo boot PROM. You can find the S record file on the hardware DVD:
Hardware DVD > PiCo and HX-PiCo > xxxxxxZ –
Boot PROM (where xxxxxxZ represents the part
number).
Table 10: Required equipment
42 Eclipse HX Upgrade Guide