Clear-Com HX System Frames - Manual (Page 119)

10. Select Program Flash from the FDT. Confirm that FDT reports the image has been written
successfully.
Important note:
If the E-MADI64 card fails to upgrade, reset (re-seat) the E-MADI64 card and select Program
Flash from the FDT again.
If you are using a USB-to-serial adaptor, the adaptor may have to be unplugged and re-
plugged to enable the upgrade to start on some computers. If you are running the EHX
application, ensure that EHX is configured for Ethernet and not serial connection. When the
upgrade is complete, you can also do the following:
1. Remove the E-MADI64 card from the matrix.
2. Remove the MVX serial cable (CAB-MVX-48Z).
3. Remove jumper J1000.
4. Repeat steps 7 through 11 for each remaining E-MADI64 card.
11.2 Upgrading the E-MADI64 application, DSP and FPGA
code using EHX
You can upgrade the E-MADI64 application, DSP and FPGA code using EHX and an Eclipse matrix.
If you are using an Ethernet connection, an EHX configuration map is required with the correct IP
address configured.
Note:
With E-MADI64, you can upgrade the FPGA code in exactly the same way as the application and
DSP code
.
*.fwc format files are used in the download of the E-MADI64 application code, the DSP code, and the
FPGA code. The software DVD contains the E-MADI64 application and DSP code:
• Software DVD > Eclipse HX-Omega-Median-Delta > E-MADI Application
• Software DVD > Eclipse HX-Omega-Median-Delta > E-MADI DSP
The hardware DVD contains the E-MADI64 FPGA code:
• Hardware DVD > Eclipse HX-Omega-Median-Delta > E-MADI FPGA
Place the application, DSP and FPGA code files in a location that EHX can access. When these files
are downloaded to the matrix, all the E-MADI64 cards that have been fitted to the matrix will be
upgraded.
Tip: For help with selecting the other procedures you require for upgrading to Eclipse HX v7.5, see
the quick reference procedures tables in 2 Selecting Upgrade Procedures.
112 Eclipse HX Upgrade Guide