9 upgrading e-que cards, 1 identifying mk1 and mk2 e-que cards, Upgrading e-que cards – Clear-Com HX System Frames User Manual
Page 91: Identifying mk1 and mk2 e-que cards
9 Upgrading E-QUE cards
The following chapter describes how to upgrade E-QUE cards (both MK1 and MK2).
Note:
This guide is laid out in the order in which you must upgrade your Eclipse HX software and hardware
devices. For a quick reference to upgrading your system, see
3 Quick reference: Upgrading to Eclipse HX.
9.1 Identifying MK1 and MK2 E-QUE cards
To identify the E-QUE card is a MK1 or a MK2 card, run a firmware report in EHX. To use the
Firmware report tool:
a. Go to EHX> System> Layout .
b. Right click the matrix icon.
c. Select Firmware > Firmware report.
You can also identify MK 1 and MK 2 cards visually.
The MK 1 E-QUE card is
green
. It also features a large chip in the upper right hand corner of the PCB
(as it is installed in the matrix):
Figure 52: MK 1 E-QUE card detail
84
Eclipse HX Upgrade Guide