CognitiveTPG A760 User Manual
Page 36
A760 User Guide: Programming Supplement
Chapter 4: Programming commands
36
Revision F January 2010
Select receipt or slip for setting line spacing
ASCII
ESC c 1 n
Hexadecimal 1B 63 31 n
Decimal
27 99 49 n
Value of n:
1, 2, 3
Select receipt
4
Select Slip
Default of n:
1
Selects which station receives the effects of the following
commands:
1.
Select Default Line Spacing (1B 32)
2.
Set Line Spacing (1B 33)
3.
Add n extra dot rows (16 n)
Exceptions
This command is ignored if n is out of range.
Select paper sensors to output paper end signals
ASCII
ESC c 3 n
Hexadecimal 1B 63 33 n
Decimal
27 99 51 n
Value of n:
If either bit 0 or bit 1 is on, the paper roll near-end sensor
is selected as the paper sensor outputting paper-end
signals.
If either bit 2 or bit 3 is on, the paper roll-end sensor is
selected as the paper sensor outputting paper-end signals.
Bit
Position Hex
Decimal Function
0
Off
00
0
Paper roll near-end
sensor disabled
On
01
1
Paper roll near-end
sensor enabled
1
Off
00
0
Paper roll near-end
sensor disabled
On
02
2
Paper roll near-end
sensor enabled
2
Off
00
0
Paper roll-end
sensor disabled
On
04
4
Paper roll-end
sensor enabled
3
Off
00
0
Paper roll-end
sensor disabled
On
08
8
Paper roll-end
sensor enabled
4, 5, 6, 7 –
–
–
Undefined
Range of n:
1–255
Default of n:
15
Specifies the paper sensor to output a paper end signal.
Multiple sensors may be selected to signal when paper
has run out. When multiple sensors have been selected,
anytime one of the sensors detects a paper end, the
paper-end signal is output.
When this command is executed a sensor is switched.
The paper-end signal switching is delayed depending on
the receive buffer state.