CognitiveTPG A760 - Manual (Page 77)

A760 User Guide: Programming Supplement
Chapter 4: Programming commands
77 Revision F January 2010
f = 4 link logo print before cut
Prints a logo after the skip distance of “s” before a
logo and “p” past a logo and performs a knife cut
(1F 03 16 04 s p).
Immediately before executing a knife-cut
command, if s > 0, execute the following:
• skip (feed paper) “s” dot rows (15 s command)
• stop background merging (1D 9B 1 command).
Save previous background merging value, so
logo prints in the clear
• set centered justification (1B 61 1 command),
saving the previous justification
• if a logo at index F3h is currently defined,
print the logo by sending print downloaded bit
image, normal size (1D 2F 0 command), without
changing the value of current logo.
• reset justification to previous value
(1B 61 [previous value])
• skip (feed paper) “p” dot rows (15 p command)
a minimum value of 90h, to ensure knife cut
occurs after the logo
• restore background merge suspension
(1D 9B [previous value])
Related information
This command is utilized in the CognitiveTPG LogoEZ ®
utility. The utility can be used to pre-configure new
printers with a default colorization setup without requiring
any application changes. The default setup was designed
to provide a general level of colorization features that
would not affect the printer operation. You can expand
beyond the default features of the utility by modifying the
application at the host. However, do not attempt to
modify the settings within the utility.
LogoEZ ® utility default settings:
f = 1: s = 1H
a = 30H
f = 2: s = 32H
r = 19H
f = 3: s = 1H
r = 7H
t = 1H
f = 4: s = 30H
a = A0H