CognitiveTPG A760 - Manual (Page 78)

A760 User Guide: Programming Supplement
Chapter 4: Programming commands 78 Revision F January 2010
Set LogoEZ ® attribute mapping
ASCII US ETX ETB a m s
Hexadecimal 1F 03 17 a m s
Decimal
31 03 23 a m s
Values: a = attribute map selector
a , m, s = 0, 0, 0 turn off attribute mapping (all 3 bytes required)
a = 1 selects first attribute mapping definition (of two available)
a = 2 selects second attribute mapping definition
a = 1 or 2, if m = 0 mapping 1 or 2, respectively, is turned off
The following “s” bits and “m” bit 7 set the attributes that
substitute for the mapped set:
Attributes substituted table
m bit on attributes substituted
7 Bold substituted
s bit on attributes substituted
0 Italic
1 Reverse
2 Underline
3 Double high
4 Double wide
5 Compressed print
6 Alternate color
7 Color reverse
continued…
A word (2 bytes) is used to identify the attribute mapping,
with “m” bits 0 – 6 identifying which original attributes
should be mapped:
Original attribute mapped table
m bit on attribute mapped
0 Bold
1 Italic
2 Reverse
3 Underline
4 Double high
5 Double wide
6 Compressed print