Controlled Products Systems Group 1834-080 - Manual (Page 20)

1.10 Postal Lock Installation
At some locations, such as gated communities, it will be necessary to provide access to the mail
carrier so that they can deliver the mail. Mail carrier access will be provided by the installation of an
Arrow Postal Lock. This is the same lock that the Post Office uses for gang mailboxes. These locks
are not available to the public. The installer or the building owner/manager will have to call the Post
Office and arrange for the installation of this lock into the telephone entry system. All DoorKing
commercial telephone entry systems are designed to accept installation of the postal lock.
Prior to installation of the postal lock, be sure power to the telephone entry system is turned off.
1. Remove the hole plug on the faceplate of the telephone entry system.
2. Cut the wire tie wrapped around the micro switch next to the postal lock access hole.
3. Remove the two hex nuts from the postal lock-mounting studs. Mount the postal lock
on the two studs and secure with the hex nuts.
When the lock is installed, check to be sure that the pawl of the lock, in its extended position, is
depressing the micro switch (the micro switch is wired normally closed). When the mail carrier inserts
his key and turns the postal lock, the pawl is withdrawn and the micro switch will activate the relay
that has been programmed for this function for the programmed strike time.
DOORKING, INC., INGLEWOOD, CA 90301
Date: Dwg. No.
Postal Lock Installation Detail
Rev.
Title:
3/03 A M1800-065-8
Postal Lock Installation Detail
1
2
Common to Terminal 6
Normally Closed to Terminal 4
3
3
Micro-switch is pre-wired. Controller terminals are
shown for clarification only.
1
Micro-switch is wired Normally Closed. Switch is
held “open” by tie-wrap or postal lock.
4
4 Postal lock supplied by others.
2 Cut tie-wrap only if postal lock is installed.
Page 20 1835-065-R-10-11