Controlled Products Systems Group 1834-080 User Manual
Page 40
3.4.4
Programming the User Message – 1837 Systems
The user message is displayed on the top four lines of the 1837 display. This message can be a
maximum of 80 characters (spaces count as a character) and is entered into the system memory in
four blocks. The example below shows how the sample message was divided into four blocks and
centered on the screen. Use the blank matrix to organize your own message. Only upper case
letters, numbers and spaces can be programmed from the system keypad.
Factory Default User Message: This Space is For Your User Programmable Message
NOTE: The factory default message was programmed from a PC, therefore upper and lower case
letters are allowed.
Example
WELCOME TO THE OAKWOOD CONDOMINIUMS PLEASE DRIVE CAREFULLY
1 2 3 4 5 6 7 8 9 10
11
12
13
14
15
16
17
18
19
20
Block
1
W
E
L
C
O
M
E T
O T
H
E
Block
2 O A K W O O D C O N D O M I N I U M S
Block
3 P L E A S E D R I V E
Block
4 C
A
R
E
F
U
L
L
Y
1 2 3 4 5 6 7 8 9 10
11
12
13
14
15
16
17
18
19
20
Block 1
Block 2
Block 3
Block 4
After organizing the user message in the matrix above, follow the instructions below to enter the
message into the system. After each desired letter, number or space is displayed on the directory,
remember to press * to enter that character. Spaces count as a character and must be entered into
memory as a character. After a complete block has been entered, press * to enter the block, then
start the next block.
1. Press *80 and enter the four-digit MASTER CODE _ _ _ _ (beep). The screen will
display: BLOCK 1.
2. Enter the characters into block 1. Remember to press * (beep) after each character.
3. After the last character in block 1 has been entered, press * (beep) to enter the block.
The screen will display: BLOCK 2.
4. Repeat steps 2 and 3 to enter characters into block 2. The screen will display: BLOCK 3.
5. Repeat steps 2 and 3 to enter characters into block 3. The screen will display: BLOCK 4.
6. Repeat steps 2 and 3 to enter characters into block 4.
7. After all four blocks are entered, press * to enter them into the system memory.
8. Press 0# together to end this programming step (beeeeeep).
Page
40
1835-065-R-10-11