Controlled Products Systems Group 1834-080 - Manual (Page 46)

3.5.8 Delete Area Codes
This program sequence deletes area code numbers that have been programmed into the system.
1. Press *24 and enter the four-digit MASTER CODE _ _ _ _ (beep). When the system
is set for 10 area codes, the display will show 0 – 9 AAC POINTER. When the
system is set for 255 area codes, the display will show 000 – 254 AAC POINTER.
2. Enter the area code pointer (0 – 9 when set for 10 area codes) _ then press * (beep).
The display will show 4 DIGIT AREA CODE.
2A. Enter the area code pointer (000 – 254 when set for 255 area codes) _ _ _ then
press * (beep). The display will show 4 DIGIT AREA CODE.
3. Enter # # # # then press * (beep).
4. Repeat steps 2 and 3 to delete additional area codes.
5. Press 0# TOGETHER to end this programming step (beeeeeep).
3.5.9 Display Phone Numbers (1834, 1835, 1837 Systems Only)
Use this programming sequence to display phone numbers programmed under known directory
codes, i.e. if you wanted to see what phone number was programmed under directory code 271. This
programming sequence will not allow you to delete phone numbers.
1. Press *06 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.5.1) then press * (beep).
3. The phone number programmed under the directory code entered in step 3 will be
displayed on the LCD. If C C C C C C C is displayed, this indicates that no phone
number has been programmed under the entered directory code. If the first digit is
flashing, this is the area code reference code and indicates that the number
displayed is a long distance or 10-digit number.
4. To display additional phone numbers press * and repeat step 2.
5. Press 0# TOGETHER to end this programming step (beeeeeep).
3.5.10 PBX Line Access Code Programming
If the telephone entry system is connected to a PBX telephone system rather than a dedicated C.O.
line, you may need to set the unit to dial a line access code prior to dialing the resident phone
number. Typically, the line access code is “9”, but check with the PBX system administrator to be
sure.
1. Press *09 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the line access code number _ then press * (beep).
3. Press 0# TOGETHER to end this programming step (beeeeeep).
NOTE: To change a line access number, enter the correct number in step 2. To
delete a line access number, enter # in step 2.
Page 46 1835-065-R-10-11