SKC DataTrac for the Leland Legacy - Manual (Page 21)

18
SKC Pump Scheduler
Figure 19. Pump Schedule Containing Programs
Figure 20. Programming Buttons
Pump Schedule
The Pump Schedule (Figure 19) contains pump programs (or pump schedules) set
by the Program Edit Bar. The pump is programmed for a sampling operation by
sending this list of programs to the pump‘s memory. The Pump Schedule is built
by using the Programming butt ons described in the next section. The maximum
number of programs that can be contained in the Pump Schedule is 26.
Before entering a program into the Pump Schedule, go to the Scheduler Options
window (Figure 35) to reset data and pump history.
Programming Buttons
The Programming buttons (Figure 20) select the program parameters, insert
programs into the Pump Schedule, write programs to the pump, and read programs
from the pump.
Button Function
Clr ..........................erases the program in the Program Edit Bar
+Day ......................adds one day to the program in the Program Edit Bar, which is
useful for programming same start and stop times on consecutive
days, or use Repeat Scheduler (see page 26)
Insert .....................places the program displayed in the Program Edit Bar into the
Pump Schedule
Cut .........................clears the selected (highlighted) program in the Pump Schedule
and places it into the Program Edit Bar where it can be edited
FromPump ...........reads the program stored in the pump and displays it in the Pump
Schedule
ToPump ................writes the program displayed in the Pump Schedule to the
pump