SKC DataTrac for the Leland Legacy - Manual (Page 32)

29
Example Scheduler Program
Repeat Scheduler
If the user wishes to repeat the example schedule for the next 10 weeks, the Repeat
Scheduler could be used to save entry time (refer to Figure 37).
1. In the Pump Scheduler, set up a regular program (see pages 16-24).
2. At the bott om of the window, click on the Repeat Schedule box (a check mark
should appear).
3. Click on the Weekly butt on.
4. Click in the Execute Count box and enter the number 10.
5. Click on the ToPump butt on to send the program to the pump.
Cycle Scheduler
To set up the same scenario in the Cycle Scheduler, follow this procedure (refer to
Figure 36):
1. In the SKC Pump Scheduler, go to the View menu. Select Cycle Scheduler.
2. Go to the Start Date, Time section and select the start date of Mar 17. Click in
the Time box. Use the  keys to select 8:00 AM or highlight the digit to be
changed, and type in the desired number.
3. Move to the Number of Cycles box, highlight the current entry, and type
in
5.
4. Go to the Cycle Setup section. Click in the Run box and highlight the current
entry. Type in 8. Click in the Hold box, highlight the current entry, and type in
16 (time between runs). Choose hours as the unit of time.
5. Go to the Flow Rate section and click on the Change Flow butt on. Select a fl ow
rate of 10 L/min and click OK.
6. Verify that the schedule is correct by reviewing the Cycle-Scheduler Times
window. The horizontal Duty-Cycle Visualizer bar graph at the bott om of the
window can be used as a visual cue as to how much of the time the pump will
be running.
7. Once the schedule is verifi ed, click on the Send Schedule to Pump butt on.