SKC DataTrac for the Leland Legacy - Manual (Page 24)

21
SKC Pump Scheduler
Figure 27. Clock
Figure 29.
Select 4:15
Figure 28. Clock Resolution
Click here
Figure 26. Calendar
Calendar
The Calendar (Figure 26) shows the time interval
over which the pump can be programmed. Use the
Calendar to select the start and stop dates for the
scheduled sample run.
Selecting a Date
To select a date, click on it then click on the Start
Date/Time or Stop Date/Time cell in the Program
Edit Bar to enter the date into that cell. Use the right
and left arrows to select a diff erent month.
Clock
The Clock (Figure 27) consists of a clock face, a digital
display corresponding to the time on the clock face,
AM and PM butt ons, and the current date and time. The
clock face perimeter is divided into 10, 15, and 30-minute
and 1-hour intervals depending on the selected clock
resolution (Figure 28).
Clock Resolution
To change the Clock Resolution or time
intervals to 10, 15, or 30 minutes or 1 hour,
select the Clock Resolution command from
the View menu (Figure 28). Clock Resolution
can also be selected by clicking on the clock
face perimeter between the digits.
Selecting Time Using the Clock Face
To select the start or stop times, select the Clock
Resolution (Figure 28), click on the clock face
perimeter, the AM or PM butt on, and then click
on the Start Date/Time or Stop Date/Time cell of
the Program Edit Bar.
Example: To set the time to 4:15 PM, select
“15 minutes” from the Clock Resolution menu
(Figure 28), click on the clock perimeter at 4:15
(Figure 29), and click on the PM butt on.