Vanguard LTCA-10, LTCA-40, WRM-10P, WRM-40 - Manual (Page 14)

LTCA VERSION 2.xx SOFTWARE MANUAL REV 3
12
If you would like to pick a completely custom color, you can click on the “Custom”
tab. The following color picker will be displayed:
You can also select a color from any pixel on the screen by clicking on the “Select...”
button. This will turn your mouse cursor into an eyedropper. Move the eyedropper
over an area on the screen and the underlying color will be displayed in the “New”
color swatch area in the “Colors” window. When you have found the color you like,
click to select it.
WRM-10P and WRM-40
The WRM is capable of reading two static resistance values at the same time, and
their values are referred to as “R1” and “R2” on the graph. The LTCA software can
also calculate each resistance’s value at a reference temperature. These values are
referred to as “R1s” and “R2s”, respectively.
LTCA-10 and LTCA-40
In static resistance test mode, the LTCA is capable of reading three static resistance
values at the same time, and their values are referred to as “R1”, “R2”, and “R3” on
the graph. The LTCA software can also calculate each resistance’s value at a
reference temperature. These values are referred to as “R1s”, “R2s”, and “R3s”,
respectively.
In dynamic resistance test mode, only the “R1” resistance values are recorded over
time. For dynamic resistance tests, the LTCA software displays the resistance curve
for “R1”, the test current graph for “R1” (referred to as “Test Current”), and the LTC
motor current graph (referred to as “Motor Current”). The colors for each graph can
be customized.