Vanguard LTCA-10, LTCA-40, WRM-10P, WRM-40 - Manual (Page 64)

LTCA VERSION 2.xx SOFTWARE MANUAL REV 3
62
“Lower” – Lower control for a load tap changer.
“Save Test” – Saves the complete test record.
“Exit” – Exits the testing window and returns to the main application window.
d. Status Section
Displays the current status of the test being performed.
Click on the “Start Test” button to start running the test.
8. The status section of the testing window will be updated to show the current status of
the test as shown below:
9. Once the resistance reading is stable, the values are displayed in the status section as
shown below:
Click on the “Accept Test” button to save the current reading. The saved reading values
will be listed in the section above the buttons:
The reading values for the selected tap will be saved and testing will continue to the
next tap position. Click on the “Accept Test” button again to store the reading for the
next tap position. Repeat this process until the readings for all tap positions have been
stored: