Progressive International Electronics PCXZ - Manual (Page 16)

Progressive International Electronics PCXZ
Version 4.2/April 2005 Page 8
PCXZinstall
System Installation
Dispenser & Reader Specific Installation
Gilbarco CRIND
Note all warnings at the beginning of installation section.
Instructions for DBox installations in this manual are for the specific DBoxes supplied by dispenser manufacturers. If using DBoxes
supplied by Progressive International, refer to the Installation Guide which accompanies PIE’s DBox.
Following instructions on preceding pages of installation section of this manual, install PCXZ,
configurator box(es) and dispenser. After successfully testing the dispensers using the PCXZ system,
then follow these specific instructions for connecting the Gilbarco reader. See Diagram: PCXZ to Gilbarco
Dispenser/CRIND.
1. Locate the reader connector on the PIE dual Gilbarco configurator box. Plug the appropriate
cable supplied by PIE into this connector and plug the other end into the Gilbarco CRIND
distribution box or the PIE DBox. Refer to Diagram: PCXZ to Gilbarco Electronic Dispenser/CRIND which follows.
2. Return to the PCXZ Installation Section for remaining system installation procedures.
Diagram: PCXZ to Gilbarco Electronic Dispenser/CRIND