Progressive International Electronics PCXZ - Manual (Page 44)

Progressive International Electronics PCXZ
Version 4.2/April 2005 Page 36
PCXZinstall
F4 Screen — Program Mode
F4 should be performed first in order to set up the system prices for each dispenser (fueling
position) and hose. The F4 screen is as follows.
Cash PPU Credit PPU Blend Ratio
Hose #1 0.000 0.000 000
Hose #2 0.000 0.000 000
Hose #3 0.000 0.000 000
Hose #4 0.000 0.000 000
Hose #5 0.000 0.000 000
Hose #6 0.000 0.000 000
Hose #7 0.000 0.000 000
Key in the cash and credit PPU according to dispenser number and hose number.
F2 Screen — Set Up the PC Port
Once the prices have been programmed, press F2 to connect the DOS TSR driver and to
start the communication with the controller. To use the default of 60, press the ENTER key.
The F2 screen appears as below.
Set up the PC port
(Press enter for a default of 60)
Enter the driver interrupt number (HEX):
F3 Screen — Operator Mode
F3 brings up the operator screen, in which the dispensers are controlled. As fuel is
dispensed, the dollar value and the volume dispensed will appear on the screen. The screen
appears as below.
Operator Control
F1 = Help F2 = Dispenser #
F3 = (E)Stop F4 = (A)Resume
F5 = Collect F6 = Grade #
F7 = Preset $ F8 = Authorize
F9 = Totals F10 = Exit
PGDN = Next Dispenser HOME = Dispenser 1
PGUP = Prev Dispenser END = Dispenser 32