Progressive International Electronics PCXZ - Manual (Page 40)

Progressive International Electronics PCXZ
Version 4.2/April 2005 Page 32
PCXZinstall
System Installation
Dispenser & Reader Specific Installation
Nuovo Pignone Electronic Dispenser
Note all warnings at the beginning of installation section.
Instructions for DBox installations in this manual are for the specific DBoxes supplied by dispenser manufacturers. If using DBoxes
supplied by Progressive International, refer to the Installation Guide which accompanies PIE’s DBox.
Following instructions from installation section of this manual, mount PCXZ and configurator box(es).
Then, follow specific instructions for connecting PCXZ system to the Nuovo Pignone dispensers. Refer
to the PIE RS485 DBox Connections diagram following this section.
1. Connect the RS485 style configurator box to the RS485 DBox using the appropriate cable
supplied by PIE.
2. Connect the Nuovo Pignone RS485 communication lines from each dispenser to the PIE
RS485 DBox board. Refer to Diagram: PIE RS485 DBox Connections and Diagram: PCXZ to Nuovo Pignone Electronic
Dispenser which follow.
3. Return to the PCXZ Installation Section for remaining system installation procedures.
Diagram: PIE RS485 DBox Connections