Progressive International Electronics PCXZ - Manual (Page 17)

Progressive International Electronics PCXZ
Version 4.2/April 2005 Page 9
PCXZinstall
System Installation
Dispenser & Reader Specific Installation
Wayne/Dresser Electronic Dispenser
Note all warnings at the beginning of installation section.
Instructions for DBox installations in this manual are for the specific DBoxes supplied by dispenser manufacturers. If using DBoxes
supplied by Progressive International, refer to the Installation Guide which accompanies PIE’s DBox.
Following instructions on preceding pages of installation section of this manual, install PCXZ and
configurator box(es). Then, follow specific instructions for connecting PCXZ system to the
Wayne/Dresser DBox. Refer to Diagram: PCXZ to Wayne/Dresser Dispenser.
1. Disconnect the Wayne/Dresser console from the distribution box and connect the
Wayne/Dresser style configurator box to the DBox using the appropriate cable supplied by
PIE. See Diagram: Wayne/Dresser DBox Connection Guide at end of this section.)
2. Return to the PCXZ Installation Section for remaining system installation procedures.
3. If configuring for liter units, ensure that pump jumpers DA and DB at position JP1 are
installed. See Diagram: PCXZ Connector/Jumper Layout.
Diagram: PCXZ to Wayne/Dresser Electronic Dispenser