Progressive International Electronics PCXZ - Manual (Page 19)

Progressive International Electronics PCXZ
Version 4.2/April 2005 Page 11
PCXZinstall
System Installation
Dispenser & Reader Specific Installation
Wayne/Dresser CAT
Note all warnings at the beginning of installation section.
Instructions for DBox installations in this manual are for the specific DBoxes supplied by dispenser manufacturers. If using DBoxes
supplied by Progressive International, refer to the Installation Guide which accompanies PIE’s DBox.
Following instructions on preceding pages of installation section of this manual, install PCXZ,
configurator box(es) and dispenser. After successfully testing the dispensers using the PCXZ
system, then follow these specific instructions for connecting the Wayne/Dresser reader. See
Diagram: Typical PCXZ Controller to Wayne/Dresser Dispenser/CAT and Diagram: DBox for Wayne/Dresser CAT
following this reader installation section.
1. Locate the reader connector on the PIE dual Wayne/Dresser configurator box. Plug the
appropriate cable supplied by PIE into this connector and plug the other end into the Wayne
CAT distribution box supplied by PIE. Connect all the existing Wayne/Dresser CAT’s into the
PIE RS485 DBox.
2. Return to the PCXZ Installation Section for remaining system installation procedures.
Diagram: PCXZ to Wayne/Dresser Electronic Dispenser/CAT