Progressive International Electronics PCXZ - Manual (Page 36)

Progressive International Electronics PCXZ
Version 4.2/April 2005 Page 28
PCXZinstall
System Installation
Dispenser & Reader Specific Installation
Bennett Electronic Dispenser
Note all warnings at the beginning of installation section.
Instructions for DBox installations in this manual are for the specific DBoxes supplied by dispenser manufacturers. If using DBoxes
supplied by Progressive International, refer to the Installation Guide which accompanies PIE’s DBox.
Following instructions on preceding pages of installation section of this manual, install PCXZ and
configurator box(es). Then, follow specific instructions for connecting PCXZ system to the Bennett
dispensers. Refer to Diagram: PCXZ to Bennett Electronic Dispensers.
1. Connect the data communication wires from the Bennett dispensers (Orange [+] and Yellow
[-]) into the dispenser connectors (J4 & J5) on the Bennett Configurator Box provided by PIE.
See Diagram: Bennett Connector Layout.
2. Locate the communication enable dip switches (SW1 & SW2) on the Bennett Configurator
Box. Beginning with dispenser #1, turn on the #1 dip switch. Test the Dispenser 1 position
for correct operation as described in the general installation section. Continue this process
for all dispensers that exist at the site. When this installation procedure is complete, a dip
switch should be turned on for each position that has a dispenser wired to it. It is important
that only connected dispensers be switched on. All unused positions must be switched off.
Refer to Diagram: Bennett Connector Layout.
Diagram: PCXZ to Bennett Electronic Dispensers