Proface PS4800 - 19 Panel PC" User Manual
Page 83
PS-4700/4800 Series (Atom N270 / Core 2 Duo P8400 Pre-installed Model) User Manual
83
Follow the steps shown below when installing the Industrial Personal Computer:
Step
Action
1
Check that the gasket is correctly attached to the Industrial Personal Computer.
NOTE: When checking the gasket, avoid contact with the sharp edges of the
Industrial Personal Computer frame, and insert it completely into its groove.
2
Install the Industrial Personal Computer in the panel opening (see page 79).
3
Insert each installation fastener securely into the slots at the top, bottom, left and
right side of the Industrial Personal Computer:
The number of slots is screen size dependent:
z
14 slots for the 15" Industrial Personal Computer.
z
18 slots for the 19" Industrial Personal Computer.
4
Insert each fastener in its corresponding slot as shown in the figure below:
5
Pull the fastener back until it is flush with the rear of the attachment hole: