Proface FP3900 - 19 Flat Panel" - Manual (Page 116)

Chapter 5 Installation and Wiring
5-7
(3) Insert each of the fasteners as shown below. Be sure to pull the fastener back until it is flush with the
rear of the attachment hole.
(4) Tighten the fastener screws equally in a diagonal pattern by using a Phillips screw driver. When tighten-
ing them, slowly increase the torque. (FP-3500T/3600T/3650T Series: 4 places, FP-3710T Series: 8
places, FP-3900T Series: 12 places)
• Do not use too much force, since it may damage the FP unit. A torque of only 0.5
N•m for the FP-3500T/3600T/3650T/3710T Series, a torque of only 0.8 N•m for the
FP-3900T Series, are sufficient to tighten these screws.
• <FP-3500T/3600T/3650T Series>
Depending on the panel condition, you can improve moisture resistant effect by increasing the
number of installation fasteners.